In Stock
Fits: Hyundai Veloster N, I30N, Kona N and Elantra N. A direct replacement HPFP (high pressure fuel pump).
What this is
An upgraded HPFP (high pressure fuel pump) for the N cars. Did you hit the limit of the OEM fuel pressure pump? Having extended start issues? Rough idle? The HPFP on the Veloster N and I30N is a known issue, and many people have been left stranded by the OEM fuel pump. This is our solution: we have tested this HPFP on stuffed turbo setups without issue, and we have proven this pump will solve your fuel pump issues on the Veloster / I30 N models. We suggest a HPFP before ECU tuning. While warranty will cover a replacement, they will just use the same pump known to cause issues. This pump will fix all your HPFP problems.
This is not the Hyundai Motorsport HPFP. However, we tested this pump with many setups, and not a single setup had fueling issues, including a stuffed turbo Veloster N and a big turbo Veloster N. It is a brand new part, the same type of pump used by Hyundai on their projects 2.0Ts. We use this pump on our project Veloster N and Elantra N.

Design
This is a direct replacement HPFP, which is needed when pushing the limits of a FBO VN and higher boost levels 22+PSI. This pump will keep enough fuel flowing to the engine even with a big turbo: it is strong enough to keep enough fuel flowing without hitting the limit on a big turbo Veloster N, and it holds fuel pressure steady at wide open throttle, even at E40 and over 450whp (proper tuning required).
As you can see from the graph below, fuel rail pressure stays consistent on this HPFP, where the OEM would dip. The way the engine starts, idles, everything is better on this stronger pump.
Features
- Rated to 400whp (can make more, we have made 455whp) if tuned correctly
- This pump is all you need to reach 400whp
- Multiple customers have dyno'd over 320WHP on this HPFP, even 1 at over 400WHP, another at 350WHP and 400WTQ, and another at 360WHP and 360WTQ, so we are confident it will solve your issue
- We also suggest a fuel injectors upgrade: the combo has made 455whp on our tuning and E blend
- Holds fuel pressure steady at wide open throttle, even at E40 and over 450whp (proper tuning required)
- Fuel rail pressure stays consistent, where the OEM pump would dip
- Direct replacement; perfectly suited for all N's, from no mods, to FBO car or stuffed turbo car
- Our customers run it without issue on everything from FBO JB4 to Lap3 big turbo kit to Elantra Turbo to our own Stuffed turbo, and from FBO ECU tune to FBO no ECU tune. Basically every setup you can think of, this pump has powered without issue.

Options
- Add HPFP Line to Rail: No or Yes. Choose Yes to add the HPFP line to the rail.
Installation notes
This pump does not require tuning, and many owners buy this pump to avoid OEM pump issues with no mods. Make no mistake about it, though: the HPFP requires tuning, and if your tune is bad you will get cuts on ANY HPFP.
N75 Motorsports recommends pump replacement before tuning to ensure tune safety, unless running a low boost Stage 1 tune. This is due to the extremely weak HPFP from factory: the HPFP has been known to fail on the OEM tune, and on a high boost tune we see it as absolutely a necessity. We change the way the HPFP acts within the tune even on an OEM pump; however, this is again for tune safety. We highly suggest ECU tuning with this pump, but it is not required.
We are well aware tuners are tuning these cars on bigger turbos with the OEM fuel pump, but we ask: what happens when you're doing a pull and the HPFP decides it's time to check out? You run lean and risk the possibility of engine damage. Why? We spend good money on our cars, doing mods and tunes, so why cheap out on a part which is extremely important to your engine's longevity? We can extremely lift the HPFP pump maps in the ECU and send you on your way with the OEM pump, but why, when there is a solution available which is not only a direct replacement, but will directly add performance to the engine? In the 1.6T community we tell everyone EBCS is required; sadly the 2.0T platform requires a part which is more expensive, but no matter how we look at it, we see this as a requirement to avoid issues. Now when we talk about tuning, this is a no brainer. Data is available of the OEM crashing under high boost. Can it be tuned out? Sure, but why would you try to tune out a well known issue? The safety of your engine is most important to us. This is why we own development cars.
Please note fuel injectors on this platform are also becoming an issue; this is due to the design of the injectors. If you have fuel cuts after this pump, more than likely your injectors should be replaced or upgraded. We recommend installation by a qualified technician.
Warranty
Contact us with your order number if you have any problem with your part.
FAQ
Does this pump need a tune?
This pump does not require tuning, and many owners buy it to avoid OEM pump issues with no mods. We highly suggest ECU tuning with this pump, but it is not required. N75 Motorsports recommends pump replacement before tuning to ensure tune safety, unless running a low boost Stage 1 tune.
Is this the Hyundai Motorsport HPFP?
No. However, we tested this pump with many setups, and not a single setup had fueling issues, including a stuffed turbo Veloster N and a big turbo Veloster N.
I still have fuel cuts after fitting it. What next?
Fuel injectors on this platform are also becoming an issue. If you have fuel cuts after this pump, more than likely your injectors should be replaced or upgraded.
Where does it ship?
Free shipping within Canada. Ships to all US States, and all international countries.