IN STOCK
Fits: Universal: AEM V2 water/methanol injection systems, and it can be used on third-party systems. The conductive fluid level sensor works with the AEM V2 controller, not V1.
What this is
The AEM V2 Water/Methanol 5 Gallon Tank Kit provides a large-capacity reservoir for extended-duration injection, ideal for drag racing, diesel and high-consumption setups. It includes a conductive fluid-level sensor (compatible with the AEM V2 controller, not V1), a preinstalled 90-degree 1/4in push-lock fitting and the hardware needed to mount it. The tank measures approximately 21 x 8 x 10 in and can be used on third-party systems.

Design
A 5 gallon plastic reservoir with a conductive fluid level sensor, which comes with a flying lead for wiring to the controller, and a preinstalled 90-degree 1/4 in push-lock fitting. AEM gives the size as 21 in long x 8 in wide x 9 in tall, or 10 in at the cap. The tank mounts through four plastic mounting ears.
Features
- 5 gallon reservoir
- Conductive fluid level sensor (V2 controller only), with flying lead
- Preinstalled 90-degree 1/4 in push-lock fitting
- Approx. 21 x 8 x 10 in
- Includes mounting hardware
- Can be used on third-party systems
Installation notes
AEM's instructions say the tank must be mounted below the injection point, so fluid cannot leak into the intake tract through gravity or siphoning. Before mounting, check under the chosen spot for fuel tanks, fuel lines or other obstructions. Mount the tank upright and level: mark the four mounting points, drill them with a 3/8 in bit, and use the supplied 5/16-18 bolts, nuts and large OD flat washers, with the large washers spreading the load on the plastic mounting ears. Do not overtighten: the nuts are locking nuts and only need to be snug, and over-tightening will crack the plastic, cause leaks and void the warranty. Every tank is leak-tested during assembly and the metal fitting is bonded to the tank with a sealant adhesive, so do not try to tighten the fitting any further. We recommend installation by a qualified technician.
Warranty
AEM Electronics gives the original purchaser a 90-day warranty against defects in material and workmanship on its water/methanol injection products, from the date of the original purchase, and will repair or replace a defective part. Normal wear, improper installation, misuse, reversed polarity wiring and cosmetic damage are not covered. Contact us with your order number if you need to make a claim.
FAQ
Will the level sensor work with my AEM controller?
The conductive fluid level sensor is compatible with the AEM V2 controller, not V1.
Can I use it with another brand's system?
Yes. It can be used on third-party systems.
How big is it?
5 gallons, approximately 21 x 8 x 10 in.
Is shipping free?
FREE shipping on orders over $400 CAD (within Canada Only).