AEM

AEM V3 Water/Methanol Multi-Input Controller Kit - 0-5V / MAF / Duty Cycle / Ext MAP

  • Sale
  • Regular price $251.00 USD
Shipping calculated at checkout.


IN STOCK

Fits: Universal: water/methanol injection systems on naturally aspirated or forced induction engines. Controller and harness only.

What this is

The AEM V3 Water/Methanol Multi-Input Controller Kit is the controller and wiring harness only, letting you build or upgrade a water/methanol injection system around the signal of your choice. It accepts 0-5V, MAF (frequency or voltage), injector duty-cycle and external MAP inputs and delivers progressive, load-dependent injection with a system-status LED and color-coded harness. A pump, nozzle and reservoir are required to complete the system.

AEM multi-input water/methanol injection controller with start and full dials, status LED and test button, beside its color-coded wiring harness

Design

The input mode is set with three DIP switches under a removable cover on the back of the controller: 0-5V MAF or MAP, injector duty (0-100%), or frequency MAF in three ranges (40-220 Hz, 400-2200 Hz and 2-14 kHz). Two knobs, Start and Full, set the signal level where injection begins and where it reaches full flow, from 0 to 100%, and injection increases progressively between them. AEM says the controller automatically compensates for changes in battery voltage for consistent flow.

AEM designed the external MAP mode for engines running more boost than its internal-MAP and HD controllers cover, or for cars that already have a 0-5V MAP signal. The controller has a status LED that also flashes error codes, a test button, an externally accessible fuse and a Boost Safe output that is grounded when an error condition exists.

Features

  • Controller and harness only
  • Inputs: 0-5V, MAF frequency/voltage, injector duty cycle, external MAP
  • Progressive injection control
  • System-status LED
  • Color-coded wiring harness
  • For naturally aspirated or forced induction applications

Installation notes

AEM says the controller is not waterproof and must not be mounted in the engine bay: mount it inside the driver's compartment, where the knobs stay within reach but protected from water. The input mode can only be changed while the controller is turned off. Injector duty mode needs an active-low injector signal; multi-pulse injection, found on some diesel applications, is not supported. A pump, nozzle and reservoir are required to complete the system. We recommend installation by a qualified technician.

Warranty

AEM Electronics gives the original purchaser a 90-day warranty against defects in material and workmanship on its water/methanol injection products, from the date of the original purchase, and will repair or replace a defective part. Normal wear, improper installation, misuse, reversed polarity wiring and cosmetic damage are not covered. Contact us with your order number if you need to make a claim.

FAQ

Which signals can trigger it?

0-5V, MAF (frequency or voltage), injector duty cycle and external MAP.

Does it work on a naturally aspirated engine?

Yes. It is for naturally aspirated or forced induction applications.

Is it a complete kit?

No. It is the controller and wiring harness only. A pump, nozzle and reservoir are required to complete the system.

Is shipping free?

FREE shipping on orders over $400 CAD (within Canada Only).



Customer Reviews

Be the first to write a review
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)