ON ORDER at our distributor as of 6 November 2026
Read this first: this set is for a reground crankshaft only. Fitted to a crank at standard journal size it will clamp the crank and destroy the engine on start-up. Measure your main journals, or ask your machine shop exactly what they cut, before you order.
Fits: Hyundai i30 N 2018 on, Veloster N 2019-2022, Elantra N 2022-2026 and Kona N 2022-2023 with the 2.0L Theta II turbo (G4KH), on a crankshaft reground 0.25 mm (0.010 in) below standard. ACL's own application guide names the i30 N.
What this is
The ACL Race Series Main Bearing Set in 0.25 mm undersize: ten tri-metal shells covering all five main journals of the 2.0 litre Theta II turbo block, sized for a crankshaft that has been reground 0.25 mm (0.010 in) below standard.

Design
From ACL: tri-metal construction, with a lead-tin-copper overlay over a nickel barrier layer and a copper-lead-tin lining on SAE1010 high-tensile steel. Full 180 degree grooved uppers with matching partial grooves in the lowers, tapered groove run-out and enlarged chamfers.
A note on appearance: Race Series shells arrive dark and tarnished, with no cosmetic tin flash. Deliberate, not a defect.
Features
- 10 shells, 5 upper and 5 lower, positions 1 to 5
- 0.25 mm (0.010 in) undersize
- Block tunnel bore 56.000-56.018 mm
- Standard crank main journal is 51.942-51.960 mm, so a journal cut for this set finishes at roughly 51.69-51.71 mm; confirm against your own measurements, not against this line
- Tri-metal: lead-tin-copper overlay, nickel barrier layer and copper-lead-tin lining on SAE1010 high-tensile steel
- Full 180 degree grooved uppers, matching partial grooves in the lowers, tapered groove run-out and enlarged chamfers
- Main bearings only: there are no rod bearings in this set
- No thrust washers included
Installation notes
Grind the crank to the bearings, not the bearings to the crank. That is ACL's own guidance and it is worth following: measure the assembled bearing bores first, then have the journals finished to match, with the oil clearance you want. ACL also recommend confirming the undersize you need is actually available before the crankshaft goes into the grinder. This size is, but not every size in this family still is, so ask us first if you are planning a different cut.
No thrust washers are included; this set is ten shells only. A crankshaft that has been reground usually needs its thrust faces addressed as well, so check thrust clearance on assembly.
Not sure this suits your car? Ask us before ordering; we would rather check the fitment than process a return.
Warranty
Contact us with your order number if you have any problem with your part.
FAQ
Can I use this set on a standard crankshaft?
No. It is for a reground crankshaft only. Fitted to a crank at standard journal size it will clamp the crank and destroy the engine on start-up.
What journal size does it suit?
Main journals reground 0.25 mm (0.010 in) below standard. The standard crank main journal is 51.942-51.960 mm, so a journal cut for this set finishes at roughly 51.69-51.71 mm; confirm against your own measurements.
Are rod bearings or thrust washers included?
No. This is a main bearing set of ten shells only, with no rod bearings and no thrust washers. Check thrust clearance on assembly, since a reground crankshaft usually needs its thrust faces addressed as well.