Fits: Hyundai Veloster N 2019-2022, Hyundai i30 N 2017 onward, Hyundai Elantra N 2022 onward and Hyundai Kona N 2022-2023 (all 2.0T N).
What this is
Our catless upper downpipe for the 2.0T Hyundai N cars. It replaces the OE upper downpipe and deletes the primary catalytic converter. It is made from 304 stainless steel, with a turbo-matched, machined flange and a laser-engraved N75 Motorsports logo. With no cat it flows more than the OE downpipe and gives a deeper exhaust tone. It is N75 Motorsports Stage 3 approved, made to meet our Stage 3 tuning requirements, and made in Europe for N75 Motorsports.
On an ECU tune it adds 25+ whp; see our Elantra N ECU Calibration on Spare ECU (2022-2023), Elantra N ECU Calibration on Spare ECU (2024-2026) and Kona N ECU Calibration on Spare ECU. It is a simpler, lower-cost alternative to our full 4-inch downpipe with 200-cell high-flow cat.
Design
This is the upper section of the downpipe, running from the turbocharger flange down to the lower flange. The flange is machined and matched to the turbo. The pipe starts as a 3.5-inch dump at the flange and necks down to 2.75 inch. It is made from 304 stainless steel. Without the cat, exhaust flow is higher than through the OE downpipe, and the tone is deeper.
Features
- N75 Motorsports Stage 3 approved; made to meet our Stage 3 tuning requirements
- Turbo-matched, machined flange
- 3.5-inch dump from the flange, necking to 2.75 inch
- 304 stainless steel
- Catless, with higher flow than the OE downpipe
- Deeper exhaust tone
- Adds 25+ whp on an ECU tune
- Bolts in as an OE replacement
- Laser-engraved N75 Motorsports logo
- 36-month warranty to the original purchaser
- Made in Europe for N75 Motorsports
Options
- Add N75 Hardware (Fouler and Studs/Nuts and Washers): No or Yes (Gaskets also included). The Yes kit adds bolts for both ends of the downpipe, gaskets, our adjustable O2 sensor fouler, and studs, nuts and washers for the turbocharger flange. With No, no gaskets or hardware are included. Choose Yes unless you already have the hardware and gaskets.
- Vehicle: Veloster N / Kona N or Elantra N. The Veloster N and Kona N share one Vehicle option and the Elantra N has its own; choose the option that matches your car.
Installation notes
The downpipe bolts in place of the OE upper downpipe. With no cat, the rear O2 sensor can set a downpipe code. The adjustable O2 sensor fouler in the hardware kit spaces that sensor out of the exhaust stream so it does not flag the missing cat, and an N75 tune can also remove the code. A catless part is for off-road and competition use; check the emissions rules where you drive.
Warranty
36-month warranty to the original purchaser.
FAQ
Which Vehicle option fits my car?
The Veloster N and Kona N use the "Veloster N / Kona N" option, and the Elantra N uses the "Elantra N" option. For the i30 N, email info@n75motorsports.ca to confirm the correct option.
Do I need the hardware kit?
Choose Yes unless you already own bolts for both ends of the downpipe, gaskets, turbo flange studs, nuts and washers, and an O2 sensor fouler.
Will it set a check-engine light?
It can, because the rear O2 sensor has no cat left to read. The adjustable fouler in the hardware kit spaces the sensor out, and an N75 tune can also remove the code.
Is this Stage 3 approved?
Yes. It was made to meet our N75 Stage 3 tuning requirements.